Infrared code analizer ~ We are with 'U'

SPECIFICATIONS

Title of the project : Infrared code analizer

Domain : Embedded Systems Design

Software : Assembler, Proload

Microcontroller : 89S52 CISC Micro Controller

Power Supply : +5V, 500mA Regulated Power Supply

Display : a) LCD, HD44780 16-character, 2-line (16X2)

b) LED 5mm

Crystal : 11.0592MHz

Sensors : IR receiver

Applications : Colleges, laboratories, research institutions etc

ABSTRACT

IR detectors are little microchips with a photocell that are tuned to listen to infrared light. They are almost always used for remote control detection - every TV and DVD player has one of these in the front to listen for the IR signal from the clicker. Inside the remote control is a matching IR LED, which emits IR pulses to tell the TV to turn on, off or change channels. IR light is not visible to the human eye, which means it takes a little more work to test a setup.

This project receives the IR transmission from TV remote or any other remote. The transmitted code consists of address and data. The data is displayed on LCD module for further analysis. The device can be used to read the data of unknown dive transmission. It is also much helpful in developing new applications based on IR remote. The receiver is embedded in a solid state device with part number TSOP 1738.

This project uses regulated 5v, 500mA power supply. 7805, a three terminal voltage regulator is used for voltage regulation. Bridge type full wave rectifier is used to rectify the ac output of secondary of 230/12v step down transformer.

BLOCK DIAGRAM